AusCelebs Forums

Hi all again, I am getting very frustrated with my cap card ” FusionHDTV DV3 – T Plus” I have reinstalled all the software (For the 3rd time). I have looked for new drivers, no luck again. When I reinstall the software I get a few warning saying “This was not digitally signed by FREAKEN MS”. I can get sound, channels but no picture. Any help would be greatly appreciated in advance

so you have ignored the warning & reinstal any way & then still no picture ?

have you used the uninstal process prior to instal ?

got all the patches for that card from the fusion official site ?

if still no good, just lodge a Q&A when logged into the official fusion site, this time of day you should get an answer by 6pm your time

http://www.fusionhdtv.co.kr/ENG/Products/#dvbt

EDIT make sure you are looking for DVB-T not DB3-T card !

Thanks 8Foot I have tried all your suggetions and nothing

there is an image protection programme in Xp that affects those old cards .. if i had any other multi media open i would not get vision on the card ..usually had message " chinagraph unable to open "

So did you log in at fusion & request some info/patch then ? make sure u let them know you are using Xp home. & wait, they are in Korea so bus hrs are approx 11:30 to 6:30 South Aus time.

They will usually point you to downloading the lastest version of a suitable driver for your card & go from there. Have you actually downloaded the latest driver for your card from the site ? ( only visible when logged in ) ?

EDIT: Release Date:20080902 - Driver Version 3.68.04 is the latest for the card .. when installing it has a pull down menu to show what card you have & then it goes from there / it also has superior "uninstal driver function inbuilt.

When i had big dramas i had to remove all fusion stuff manually via C:/ All Programmes/Divico & deleted all the stuff in files then the file shells.. then i went to add or remove programmes & also did that then ran the Fusion Driver using the uninstal function - RE BOOT PC - then run the instal & go through to malarkey of instal fusion then instal it again in windows & it worked ok. without those steps i had weird errors & crashes

YeeHar, got it going again Thanks 8Foot Now back to some capping again